| Local Properties | ||
Managed Object Types | Data Object Types | All Properties | All Methods |
Properties
Name | Type | Description |
---|---|---|
checkOnly | xsd:boolean |
Do not execute the (test) failover but check if the configuration
is correct to execute the (test) failover.
If set to
If set to |
isPlanned | xsd:boolean |
Whether the failover is a planned failover or not. Note that testFailover
can also be executed in an unplanned mode. When this flag is
set to false, the recovery VASA provider must not try to connect
to the primary VASA provider during the failover.
|
policyAssociations* | PolicyAssociation[] |
Storage policies for the devices after (test)failover.
Failover should be done even if policies cannot be associated. Test failover, however, should fail if policies cannot be associated. If policies cannot be associated, VASA provider can notify the client by doing either or both of these: 1. Set the warning in the result for a replication group to indicate such a failure to set the policy. 2. Raise a compliance alarm after the failover is done.
If not specified, the default policies are used. Callers may reassign
policy later.
|
replicationGroupsToFailover* | ReplicationGroupData[] |
The replication groups to failover. It is OK for the VASA
provider to successfully failover only some groups. The
groups that did not complete will be retried.
|
Properties inherited from DynamicData | ||
None |
Top of page | Local Properties | ||
Managed Object Types | Data Object Types | All Properties | All Methods |