Modify a Virtual SAN Datastore

You can add or remove local disks from existing Virtual SAN disk groups or remove entire Virtual SAN disk groups.

Prerequisites

■	Verify that you are connected to a vCenter Server system.
■	Verify that at least one Virtual SAN disk group exists in the cluster.

Procedure

$dgs = Get-VsanDiskGroup -Cluster 'VsanCluster'
$dg = $dgs[0]
Get-VsanDisk –VsanDiskGroup $dg
$disk = New-VsanDisk -CanonicalName 'HDD-CanonicalName' -VsanDiskGroup $dg
Remove-VsanDisk -VsanDisk $disk
Remove-VsanDiskGroup -VsanDiskGroup $dg

1	Get the Virtual SAN disk group from a cluster. $dgs = Get-VsanDiskGroup -Cluster 'VsanCluster'
2	Get all Virtual SAN disks from the Virtual SAN disk group. $dg = $dgs[0] Get-VsanDisk –VsanDiskGroup $dg
3	Add a hard disk to the Virtual SAN disk group. $disk = New-VsanDisk -CanonicalName 'HDD-CanonicalName' -VsanDiskGroup $dg
4	Remove a hard disk from the Virtual SAN disk group. Remove-VsanDisk -VsanDisk $disk
5	Remove the entire Virtual SAN disk group. Remove-VsanDiskGroup -VsanDiskGroup $dg